Huawei Y6p Backlight Ways Problem | Display Light Solution

Rate this post

In this guide, we will show you the solution to repair Huawei Y6p Backlight Ways Display Light problem jumper full LCD ways display connection line paths in case you are going to troubleshoot display problems such as blank display, dark screen display, white screen (with tones), No backlight LED that is resulted from due to wet damaged or accidentally dropped issues by the users.

In the mobile repairing, field is a common problem almost 60% to 70% you will be getting mobile display light problem solution in the water damage mobile for it’s it is a common issue form display light problem because in the display light in the mobile phone have maximum voltage place because in this place you will get the boost voltage almost 40 volts maximum or 24-volt minimum depends on the brand of the mobile phone.

Huawei Y6p Backlight Display Problem is a typical case; surely this will be the moment when we use a lot of activities using an Android phone device, in this opportunity MobileRdx Team try to discuss and Provide a repair solution on the Android device Huawei Y6p backlight. Maybe some of you have the same obstacles and damage on Android phones Huawei Y6p that have no light on the display or its LCD.

Handset Fault Type.

Display Light not Working.
Display Light Circuit Damage.

What Is An Huawei Y6p Backlight Or LCD Display?

To start with, an LCD is the digital display interface of your phone, it is the interactive part where you see what goes on as you operate or tap on an icon, watch a video, play music or games, etc. When the LCD (liquid crystal display) is faulty or damaged, you one won’t be able to enjoy it as before. This is where the LCD backlight comes in, the backlight is a series of LEDs (light-emitting diodes) well arranged and suited in the screen layers to give illumination to the LCD screen.

Huawei Y6p Backlight Ways Problem Solution

To fix the dark screen Huawei Y6p Display Light problem, you may first try to replace or install a new Display screen module, to easily confirm if the LCD’s backlight LED’s were still working or already damaged.

You can also check the LEDs using the multimeter if you can manage without damaging the LCD flex connector.

If the newly installed LCD still shows the same problem and the LED light doesn’t light up, refer to the solution above and locate the highlighted components on the PCB board.

Following are some of the Huawei Y6p Display Light problems that you might encounter:

Problems

White Display
No Display
Lines on Display
Low Light on Display
No Backlight

How To Repair Huawei Y6p Display Backlight Problems:

Here are some useful steps that are required for the faulted LCD light mobile repair. You need to follow these steps for the perfect mobile repair. All steps are used as the general mobile repair.

Try to test the current on the display Lights pins. If the display links are broken or missing.
You can make a direct jumper by the image diagram above.
For the display connector repair. You need to start first from the motherboard connector then display the panel strip connector and last LED connector at the backside of the panel.
The jumper and LED lights are working fine but the LED current is missing. In this case, You need to fix this issue from the Lights controller section.
There could be a separate section or build-on power chip. In a separate section of the LED lights controller. There could be light current filter chip or transistor for a auto-switching.
The auto switch may help to refuse battery life. The display lights are the major things that can drain the battery fast. To learn more about the display light’s auto-switching. Anyway let us go to the point of mobile repairing in steps.

If you have further questions, please don’t hesitate to leave a comment.

Note: Every repairing solution posted here was tested by at least one member of our team. Use the information available here at Your Own Risk. We are not responsible if any harm comes to your device during the repair process.